Home Introduction Products Trade online Contact us
Jet Mill Series
QS Horizontal Disk-Type Jet Mill
QLD/QLZ Liquified Bed-Type Jet Mill
QON Circulation Tube Type Jet Mill
QBN450 Target Jet Mill
Machinery Mill Series
JCW Hammer Type Machinery Mill
JCF Classifier Mill
JBL Pin Machinery Mill
JJ (A) Cutting Type Pulverizer
JCL Double-Shaft Micron Grinder
ZDM High Efficient Vibrating Micron Mill
Whey Pulverizer
Grading Series
FYW Grader
FQZ Classifier
FSZ classifier
Drying Series
QJD Batch Heating Agitator Drier
YP Spray Drier
XSZ Spin Inner-vaporization Drier
ZL Vibrating Fluid Bed Dryer
Other Series
BWF-250 fine powder packing machine
CZL500 pelletizer, CZL750 pelletizer
SSB classifier
JCL Double-Shaft Micron Grinder

Principle:
JCL is compact and reasonable in construction, consisting of a grading device, making the classification of powder into grade by a single step. It eliminates overground powder, saving the unnecessary energy requirement. It is connected to draught fan so that the heat generated can be instantly dissipated. Thus it is applicable to grind thermal sensitive heat-labile substances. It can be adapted to various operation conditions giving a narrow distribution of particle sizes, and can grind chemicals, foodstuffs, pharmaceuticals, plastics, drugs, cosmetics, dyestuffs, pigments, resins, grains, etc.

The complete set is vertically installed, consisting of a grinding chamber and a classifying chamber its construction and working principle are shown in the figure. In operation, by the negative pressure produced by a bleeding of steam in the outlet, the feed in a quantitative rate, passes through screw conveyer and a hopper into the grinding grathngchamber. The powder produced here goes through a guiding ring to classifying chamber. As the classfying vane is revolving, the powder is objected to the influence of air dynamics and centifugal forces. The coarse particles of dia greater than the critical dia of classifying return to the grinding chamber. The particles of dia, Less than critical dia, go through the output pipe to output pipe to enter the collection.

 
Flow Diagrammatic Sketch
 
Main Technical Parameters

Model/ Parameter

Main
Power (Kw)

Rated Speed (r/min)

Capacity (kg/h)

Grinding Size (μm)

JCL320

7.5

6880

100-400

45

JCL520

22

4200

100-800

45

JCL800

45

2800

200-1000

10-30

 
 
Copyright(C)2006,Shanghai Xichuang Powder Equipment Co., Ltd(Formerly Shanghai Chemical Machinery No.3 Factory) All Rights Reserved.
Supported by ChemNet ChinaChemNet Toocle Copyright Notice
│Č┼÷ď┌¤▀╣█┐┤corn