Home Introduction Products Trade online Contact us
Jet Mill Series
QS Horizontal Disk-Type Jet Mill
QLD/QLZ Liquified Bed-Type Jet Mill
QON Circulation Tube Type Jet Mill
QBN450 Target Jet Mill
Machinery Mill Series
JCW Hammer Type Machinery Mill
JCF Classifier Mill
JBL Pin Machinery Mill
JJ (A) Cutting Type Pulverizer
JCL Double-Shaft Micron Grinder
ZDM High Efficient Vibrating Micron Mill
Whey Pulverizer
Grading Series
FYW Grader
FQZ Classifier
FSZ classifier
Drying Series
QJD Batch Heating Agitator Drier
YP Spray Drier
XSZ Spin Inner-vaporization Drier
ZL Vibrating Fluid Bed Dryer
Other Series
BWF-250 fine powder packing machine
CZL500 pelletizer, CZL750 pelletizer
SSB classifier
QBN450 Target Jet Mill

Principle:
With the help of high speed airflow, the material get full crush in target (including the some times with inner wall of atomiser). Higher crushing strength, it is effective to the most of flexible and stringy material. For the recycling function of snail type separator, the treated material gets full crush and even granularity. The hexagonal and gear form target are suitable for various demand.

Features:
• With the help of high speed airflow, the material get full crush in target (including the some times with inner wall of atomiser). Higher crushing strength, it is effective to the most of flexible and stringy material.
• The low temp. operation is available, so it is suitable for heat sensitivity material with lower melting point.
• For the recycling treating function of snail type separator, the treated material gets full crush and even granularity.
• The hexagonal and gear form target are suitable for varied demand upon the material properties.
• Simple structure, no running parts, it is suitable for the batch operation.
• Noise: <80db

 
Flow Diagrammatic Sketch
 
1. Air Pressure Compressor 2. Air Cooling Dryer 3. QBN450 Target type atomizer
4. Silo 5. Electromagnetic vibrator feeder 6. Cyclone separator
7. Star-type reversing valve 8. Bag-type collector 9. Induced draft fan
Usage: Widely used in the grind of Xerox powder, algin, PVC, polypropylene, epoxy resin, konjaku flour , polyvinyl alcohol , liquorice.
 
Main Technical Parameters
Pressure
0.6-0.8Mpa
Feeding size >3mm N.W.
250kg
Feeding pressure
0.3-0.5Mpa
Throughput 10-100Kg/h Air consumption
9-10m3/min
Size
1490X1100X1020
       
 
 
Copyright(C)2006,Shanghai Xichuang Powder Equipment Co., Ltd(Formerly Shanghai Chemical Machinery No.3 Factory) All Rights Reserved.
Supported by ChemNet ChinaChemNet Toocle Copyright Notice
│Č┼÷ď┌¤▀╣█┐┤corn