Home Introduction Products Trade online Contact us
Jet Mill Series
QS Horizontal Disk-Type Jet Mill
QLD/QLZ Liquified Bed-Type Jet Mill
QON Circulation Tube Type Jet Mill
QBN450 Target Jet Mill
Machinery Mill Series
JCW Hammer Type Machinery Mill
JCF Classifier Mill
JBL Pin Machinery Mill
JJ (A) Cutting Type Pulverizer
JCL Double-Shaft Micron Grinder
ZDM High Efficient Vibrating Micron Mill
Whey Pulverizer
Grading Series
FYW Grader
FQZ Classifier
FSZ classifier
Drying Series
QJD Batch Heating Agitator Drier
YP Spray Drier
XSZ Spin Inner-vaporization Drier
ZL Vibrating Fluid Bed Dryer
Other Series
BWF-250 fine powder packing machine
CZL500 pelletizer, CZL750 pelletizer
SSB classifier
QJD Batch Heating Agitator Drier

QJD Batch Heating Agitator Drier is one kind of highly effective energy saving continuous drying equipment. It has two kind of revolution axes for selection: coil tube type (G) and vane type (Y). The coil tube type revolution axis has compact structure compact and large heat transfer area, is suitable for treating the loose granulated and powdery material; The vane type revolution axis attaches a kind of special cleaning mechanism which can eliminate the material that adhere to the vane surface, is suitable for processing the paste-like material. Comparing it with the biax stirring dryer, this kind of dryer has compact structure, low construction cost, small material crashing ratio, wide applicable scope. It is one of the newest stirring driers.

The material enters into the dryer through the feeder, being heated by the heat-transfer surface of the dryer shell body jacket and the revolution axis, at the same time is fully stirred by the revolution axis that drives by the speed adjusting motor drive, the heating surface renews unceasingly, finally is discharged out of the exit of the dryer, carries on the moisture evaporation in the transportation process and dry the material. By adjusting the charging rate, the spindle speed of the dryer as well as the opening of the poling board, controlling the control residence time of the material in the drier, thus control product moisture content. This dryer's heating carrier can separately adopt the saturated steam, heat conducting oil, hot water, negative pressure steam, etc. according to the characteristic of the dry material.

Our factory manufactured QJD series batch heating agitator drier, summarized many years' service experience of the stirring dryer, its structure synthesized the domestic and foreign similar products strong point, the coil tube type revolution axis dryer's heat transfer area is 5-160M2 and the vane type revolution axis dryer's heat transfer area is 4-125M2. At present, it is the continuous-running stirring dryer series which has the most advanced structure, and the most complete specification in China.

 
Copyright(C)2006,Shanghai Xichuang Powder Equipment Co., Ltd(Formerly Shanghai Chemical Machinery No.3 Factory) All Rights Reserved.
Supported by ChemNet ChinaChemNet Toocle Copyright Notice
│Č┼÷ď┌¤▀╣█┐┤corn